Jockey Shift Kits
This new improved (less expensive!) extended release arm was designed for Rotary top Transmissions, but also works great on all Baker 6 in a 4 speed case Trannys, as well as all Ratchet top Trannys. It will not work with electric start models (it will work with some, but not on Factory e-start primaries). It is drilled in the end so you can fit a 1/4″ heim joint attached to your linkage. Works with most stock controls too – a great way to make a foot clutch work on your ‘sickle!
This stainless steel shifter will make your turtle top trans shift like a dream.
This shift lever is the same dimensionally as the generic imported levers that other vendors sell, but it is 100% MADE IN THE USA, and 100% 304 stainless steel, and curves to the rear to get it out of the way of your leg when stopped. A 3/8″-24 threaded stud allows you tio use whatever shift knob you want.
$75.00 plus shipping
Have you wanted to Jockey shift your 4 speed electric start bike, but couldn’t figure out a reliable way to make the cable work?? Here’s your answer! This kit includes a premium cable made especially for me, by a major USA cable manufacturer (no cheap imports here!).
Here’s how the kit works: you send me your left side foot control. I alter the lever that the shift linkage normally attaches to, and ship you back a system ready to bolt in place that is reliable and SMOOTH. I prefer to sell this kit by phone, so I can discuss the bike with the owner and avoid any unnecessary delays. Turnaround time is normally 1 week from the time I get your foot control, until I ship all of the components back to you to install. Installation is so easy, even Mikey could do it.
Note: If extra quick turn around time is needed, a premium charge may apply, as well as increased shipping costs for next day air, etc.